Content

EasyEDA Pro can use system commands to draw quickly. Currently, only PCB and footprint commands are supported, and schematic diagrams and symbols are temporarily not supported.

Instructions:

  • Click on the top menu - Tools - Commands in the PCB interface or footprint interface
  • Shortcut C

After clicking, a command input box will pop up in the lower left corner of the interface.

image-20210520151853668

X-direction relative coordinate command IX

Click on the wire, shortcut C to call up the command input box, and enter IX 300 in the named input box (note that ix must be separated by a space to enter coordinates)

1-1608608691917

Y direction relative coordinate command iy

The operation mode of the relative coordinate command in the Y direction is the same as that of the relative coordinate command in the X direction.

Change layer command

The shortcut key C brings up the command input box, enter “L 2” in the input box to switch to the bottom layer.

  • Enter “L 1” to switch to the top level;

  • Enter “L 2” to switch to the top level;

  • Enter “L 3” to switch to the top silk screen layer;

The number of the corresponding layer can be seen here in the property panel layer on the right.

image-20210520151932519

find component command

The shortcut key C brings up the command input box, input “S plus the bit number of the device” to find the device in the editor and highlight it.

2-1608615530755

Modify line width

Click on the wire, and press the shortcut key C to call up the command input box, and input W to change the line width.

3-1608615906958

The search of the command is in the settings, the shortcut key setting query, or you can double-click to modify the command.

There are not many commands currently supported, and more commands will be introduced in the future.

image-20210520152359910

image-20210520152348401


goToTop