The line tool is different from the wire in that it has no electrical properties and can only be used as a drawing tool
Polyline
Polylines are different from wires. Polylines do not have any electrical properties. Polylines can be used to draw board frames. Segmentation planning cannot be used for wires.
- Top Menu - Place - Line - Polyline
- Use shortcut keys Alt + L
center arc
Used to draw an arc based on the center point in the PCB interface
- Top Menu - Place - Line - Center Arc
Two point arc
It is used to draw a two-point arc in the PCB interface.
- Top Menu - Place - Line - Two Point Arc
Three point arc
Used to draw a three-point arc in the PCB interface
- Top Menu - Place - Line - Three Point Arc
- Use shortcut keys Alt + A
round
Used to draw a circle in the PCB interface.
- Top Menu - Place - Line - Circle
- Use shortcut keys Alt + C
rectangle
It is used to draw a circle in the PCB interface. After drawing the figure, you can click the figure to modify the corresponding properties in the right panel.
- Top Menu - Place - Line - Circle
- Use shortcut keys Alt + R