Symbol Wizard
The EasyEDA Pro symbol wizard can quickly create symbols. Currently, it only supports the rapid creation of three types of symbols: DIP, QFP and SIP of IC type.
Steps:
- In the view on the left side of the Symbol Editor interface, select Wizard
- Select the type of symbol to be created
3. Set the origin
The origin is the first pin: set the first pin of the symbol as the origin, and the coordinate values of the first pin are all 0.
Set the origin at the center: Set the center position of the symbol as the origin, and the coordinate value of the center position of the symbol is 0.
Fill in the corresponding number of pins
Set the spacing of the pins
Note: The pin spacing cannot be set too small, otherwise, when generating symbols, it will cause the pin names to overlap like the picture below. **The recommended spacing is 0.15 inches. **
Orientation of pin numbers
The numbering direction is counter-clockwise circle generation
The pin numbering direction is generated from top to bottom. The difference between the two is that the position of the generated serial number of the pin is different, which is more suitable for symbols of other types of pin numbering direction.
Click to generate
Select Yes to clear the symbols in your current symbol editor and generate them.
Select Else to not generate symbols.
Generated DIP type symbols
